Maintenance method of 3D FDM printer in daily life
Preventive protection every day: After each manufacturing is completed, all accumulations of printing channels and lead screws must be sorted out. If you don’t do this, it may cause the large FDM 3D printer channel to be horizontal or the 3d big printing channel to be stuck at its upper limit. After each manufacturing is completed, check the printing nozzle to ensure that there is no accumulation. The accumulation of the nozzle may cause accessories quality problem.
Use a vacuum cleaner to clean the printing and manufacturing boudoir, to suck away all the residual materials and the squeezed out materials. Do not use ammonia-containing glass cleaner on the door, otherwise it will damage the window. Only use ethanol cleaner when cleaning up. . The 500-hour repair will clean the printing nozzle parts every about five hundred hours to completely block the power supply of the 3D printer.
Loosen the heating head screw and remove the tube, use a drill to rotate the nozzle to clean the accumulation of material inside the printing nozzle, use a needle to poke the most accumulated material in the spray, take out the new tube from the accessory kit, cut out 52 mm, and install it in the original position. Fix the print nozzle with a sleeve.
After 2000 hours of repairing a 3D printer, the print nozzle may be worn out after running for more than two thousand hours. This requires replacing a new pipe and discarding the used nozzles. The daily routine of 3D large printers maintain is shown in this article. The protection is introduced to us, we can use it in actual use after we understand it.
